Abit BD7-E User Manual page 47

BIOS Setup
Suspend Mode = 1 Min.
HDD Power Down = 1 Min.
Suspend Mode/HDD Power Down:
These two items will be enable to change setting when item Power Management is set to User Define,
theses two item will also changes as table 3-1 below.
Table 3-1: Power Management Settings
Items
Suspend Mode
HDD Power Down
Video Off Method:
Three video off methods are available: "Blank Screen", "V/H SYNC + Blank" and "DPMS". The default
is "V/H SYNC+Blank".
If this setting does not shut off the screen, select "Blank Screen". If your monitor and video card support
DMPS standard, select "DPMS".
•
Blank Screen: This option only writes blanks to the video buffer.
•
V/H SYNC + Blank: This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
•
DPMS: Initial display power management signaling.
Video Off In Suspend:
Two options are available: Yes or No. The default setting is Yes. This item determines the manner in
which the monitor is blanked.
Suspend Type:
Two options are available: Stop Grant and PwrOn Suspend. The default setting is Stop Grant.
Modem Use IRQ:
You can specify the IRQ for modem use. Eight options are available: NA
11. The default setting is NA.
Soft-off by PWR-BTTN:
Two options are available: Instant-off and Delay 4 Sec.. The default setting is Instant-off. Pressing the
power button for more than four seconds forces the system to enter the Soft-Off state when the system has
"hung".
User Define
Disabled 1 Min
12 Min 20 Min
Hour. The default setting is Disabled.
Disabled 1 Min
5 Min 6 Min
10 Min 11 Min
Min 15 Min. The default setting is Disabled.
Power Management Settings
2 Min 4 Min 8 Min
30 Min 40 Min
2 Min 3 Min 4 Min
7 Min 8 Min 9 Hour
12 Min 13 Min
Min Saving Max Saving
1 1 Hour
15 Min
14
3 4 5
User's Manual
3-13
1 Min
1 Min
7 9 10