Table of Contents
Advertisement
Standard
Appearance
Panel
Options
Custom
Panels
Option #1
Option #2
4
The Monogram compactor models ZCG3300
and ZCG3100 come with a white/black reversible
aluminum front drawer panel. Model ZCG3300 is
shipped with the white panel showing and model
ZCG3100 with the black side showing. The panels
on both models can be reversed to reveal the opposite
color side. The ZCG3500 comes with a stainless steel
wrapped panel.
Go to Step 7, page 12. Follow procedure A for
reversing door panel color if desired.
Monogram compactor models ZCG3300 and ZCG3100
are designed to accept a custom front drawer panel to
match the surrounding cabinetry.
1/4" Thick Wood Panel
• Cut panel 11-11/16" wide, 24-1/2" high.
The custom 1/4" thick panel replaces the
white/black aluminum panels and cardboard filler.
The custom panel will slide into the trim on the
drawer front, concealing raw cut edges.
Go to Step 7, page 12. Follow procedure B for
installation.
3/4" Thick Wood Panel
• Cut panel 12" wide x 24-3/4" high.
The custom 3/4" thick panel replaces the
white/black aluminum panel. Cut edges will be
seen and must be finished for best appearance.
Both the trim and drawer front panel will be
removed to make this installation.
Go to Step 7, page 12. Follow procedure C for
installation.
3/4" thick door panels, both raised and flat design,
Note:
should be constructed in the same manner as typical cabinet
doors. Order the 3/4" custom door panel from the cabinet
manufacturer. Be sure to provide the exact dimensions so
that the panel is constructed accurately.
Installation Preparation
Built-In Compactors
You can:
• Install a 1/4" thick custom panel
• 3/4" thick custom panel
• 3/4" thick custom panel and custom handle
Advertisement
Table of Contents
