GE MONOGRAM ZCG3300 WW Installation Instructions Manual page 14

14
Procedure D
3/4" thick wood panel with custom handle
• Pull the drawer out to stop position.
• Unlatch the drawer front by opening the clasp on
the right side.
• While supporting the weight of the drawer front,
remove the hinge pins on the left side.
• Lay drawer front face down on a flat surface.
• Remove 9 screws which retain the front panel and
handle.
– Save galvanized inner door.
– Discard front panel with side trim and handle.
• Place galvanized inner door onto the back side of
the finished panel.
• Position the inner door 1-5/16" below the top of the
finished panel and center, left to right.
• Use the inner door as a template. Drill 2 pilot holes
near the top and 2 at the bottom, sized to match
screws being used. (Screws are not provided)
• Drive 2 screws loosely into the bottom and 2 screw
into the top. Check to be sure the inner door is
centered left to right over the finished panel.
Tighten screws.
Select screw length carefully to avoid penetration of the
Caution:
finished side.
Installation
Built-In Compactors
Back Side Finished Panel
Galvanized Inner Door
Galvanized Inner Door
C L
1-5/16"
C L
Back Side Finished Panel