Page 3
-02- 2. ADJUST LIMIT SWITCH Adjust position for the two limit journey, refer to below picture: Adjulting knob for DOWN Adjusting knob for UP Adjusting Diagram 3.USEFUL INSTRUCTIONS a.The screen should be switched to a suitable power supply. it can be 220V / 50HZ,230V / 5OHZ.or 1 OV / 60HZ.120V / 60HZ.but the moto(s power must be same as the local voltage and frequency.
Page 4
-03- 4. INSTALLING a. Unpack the screen carefully. be sure the screen is in good condition, check all the accessories are packed inside the carton. b. Check the voltage and frequency marked on the screen is in with accordance the local power supply. It is suggested only to use the screens indoor under normal temperature and humidity.
Page 5
-04- 5 WARNINGS a.The screen can not be folded. Do not use fingers or hard objects to touch the screen surface Do not splash the milk fruit juice or other chemical doses to the screen surface. Keep the screen far away from the high temperature objects or fire.
Page 6
-05- 3.When the up and down buttons are pressed in the same time, the remote control is locked. Operation will be stopped. The system will be unlocked Wthe slop button is pressed again. 4. The power source will be cut off automatically if the motor operation has lim~.
Page 7
-06- WALL-MOUNTED MANUAL SCREEN I.STRUCTURE HOUSING RING BLACK BORDER SCREEN PULLING RING PULLING ROD 2.INSTAWNG Moving Parts afthe drive must be installed higher than 2,5 mm above above the floor or other level that could provide access to it. Choose a suitable place for installing.it is best to install two screws onthe wall, the distance aftha screwsust be equal to that of the two rings and they should be at the same level, the rings must be strong enough to loading...
Page 8
-07- TRI I'OD SCREEN PULLING ROD , STRUCTURE BLACK BORDER SCREEN ~=======T======~~ TRIPOD (E TYPE). it:!,;- • • • • • • 2 INSTALLING Choose a suitable place for installing, open the tripod feet first, pull out the upper bar to a suitable height and lock it, hang the pulling rod above to the goose neck and adjust the screen height, then finally fix/lock it at a satisfied position which you want.
Page 9
-08- TECHNICAL DATA a.Matte White Screen Gain: 1.1 Viewing Angle: 160· High color rendering, high resolution. b.Glass Beaded Screen Gain: 2.5 Viewing Angle: 60· High color rendering, high resolution. c.High quality synchronous or tubular motor is equipped in the left end ofthe screen housing.
Page 11
-10- For your retention Customer Copy customer Nama: Miss 0 Addrells: Tal. No.: Tool Modal: Serial No, or Date Code: Data of Purchase: Invoice/Receipt No"': Dealer' IS Nema(Dealar' 15 Chop): Tel. No.: This product is warranted for one year from the date of purchase. If the tool becomes defective due to faulty materials or workmanship within the warranty period.