Setting The Snapshot Period - Periodic Waveform Capture Setting - Fluke 1750 Operator's Manual

1750
Operators Manual

Setting the Snapshot Period - Periodic Waveform Capture Setting

Use the Snapshot Period screen to program the Recorder to take automatic power
conditions readings which are then stored in the recorded data stream. These snapshots
contain a phasor diagram, waveforms of current and voltage, harmonics profiles, and
other data.
You can take a snapshot manually at any time at any time while connected
over the wireless link to a Recorder. Press the Waveform icon
the View screens to take a snapshot. The message, "Snapshot Acquired"
confirms that a snapshot was taken.
44
None
10 minutes
30 minutes
1 hour
Note
Azd132.bmp
on any of
Azd135.bmp