What To Do If - Zanussi ZOP38903XD User Manual

3
1 2
Make sure that you put the glass panels (1, 2
and 3) back in the correct sequence. The mid-
dle panel (2) has a decorative frame. The
screen-printing zone must face the inner side
of the door. Make sure that after the installation
the surface of the glass panel frame (2) on the
screen-printing zones is not rough when you
touch it.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not oper-
ate.
The oven does not heat up.
The fan does not operate. The
display shows or
20
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic switch-off is on.
The Child Lock is on.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
The demo mode is activated.
.
Make sure that you install the top panel in the
seats correctly.
Activate the appliance.
Set the clock.
Make sure that the settings are cor-
rect.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child Lock".
Do a check of the fuse. If the fuse is
released more than one time, contact
a qualified electrician.
Replace the oven lamp.
1. Deactivate the appliance.
2. Press and hold the button
approximately two seconds. An
acoustic signal sounds.
3. Press and hold the buttons
and
acoustic signal sounds again and
the indicator goes out.
Remedy
for
at the same time until the
www.zanussi.com