Download  Print this page

Electrolux EHP 634 X Instruction Book

Hide thumbs

Advertisement

Quick Links

325 88-1220 Rev. 2-912

Advertisement

loading

  Summary of Contents for Electrolux EHP 634 X

  • Page 1 325 88-1220 Rev. 2-912...
  • Page 2 Sincerely Electrolux...
  • Page 3 For safety's sake, turn pots and pans so Service and repair may only be performed by the distributor, or by a that handles do not protrude, thus service organization approved by the inviting accidents. distributor. Only repair parts delivered by the distributor may be used. Never place plastic or paper, etc., on the unit.
  • Page 4: Installation

    Product liability Unpacking Our liability is limited to that which is Check to see whether the unit is stipulated by law, and covers only damaged. damage to persons and property, which results from defects in materials and Distribution damages workmanship of the unit itself. Any damages due to transportation by This liability extends for a period of 10 us or by our representative must be...
  • Page 5: Before Use

    Before use Before using the hob unit it is advised to clean the ceramic surface with the enclosed cleaning agent. Use a clean, damp cloth or tissue. Dry with a clean cloth. The decorative pattern on the ceramic surface can become scratched and marred with use, depending upon how one uses and maintains the unit, but does not adversely affect performance.
  • Page 6 Switch symbols (to the left) Switch for regulating the plate at the rear Switch for regulating the large plate at the front. Switch for regulating the double plate at the rear Switch for regulating the small plate at the front. Regulating The regulating of heat is graduation-free for all plates on a scale from 1 to 9.
  • Page 7: Pilot Light

    Pilot light Pilot light is activated when either of the zones are turned on, and will remain on until the cooking zones are switched off. Residual-Heat indicator Each plate has a residual heat indicator which remains on as long as the temperature of the cooking zone exceeds 80˚C, even if the cooking zone is switched off.
  • Page 8 Use Proper Cooking Utensils Make the most of your new ceramic- top hob unit by using proper utensils of a good quality. Only pots and pans which are expressly intended for use on ceramic- top hob units may be used. Utensils must, as a minimum, cover the entire circle which represents a given burner.
  • Page 9 (use liqud AJAX or other diswashing liquid), and well wrung. All spills must be cleaned up immediately, while the burner is still warm. Use the cleaning agent supplied with the unit. Remove spots caused by utensils with aluminium bottoms, or burned grease, by polishing with the cleaning agent supplied with the unit.
  • Page 10 Do not slide saucepans across the surface of the hob - always lift the pan when placing it on, or removing it from the ceramic surface. Wipe the bottom surface of the pots and pans with a clean dry cloth before placing them on the ceramic surface.
  • Page 11 The decorative pattern on the ceramic surface can become scratched and marred with use, depending upon maintenance, but does not adversely affect performance. Such blemishes are not covered by the warranty. Spills and melts must be removed immediately, while the burner is still warm, using the scraper supplied with the unit.
  • Page 12 The hob unit can be mounted in any type of kitchen with a table surface whose thickness is between 28 mm and 40 mm. Clearance The distance between the top side of the tabletop and the carpentry underneath must be at least 45 mm. Fixing Screw the fixing brackets out to such an extent that they can be turned in under...
  • Page 13 The unit´s externally measured length 145 mm: Cooker hood 290 mm: Two-burner standard electric hob Two-burner ceramic-top electric hob Two-burner gas hob Grill 580 mm: Four-burner ceramic-top electric hob Four-burner gas hob Installation of a single unit When mounting a single unit, be it a half-or full size unit, in a table surface which is thicker than 30 mm, it is necessary to make a special notch in...
  • Page 14 The electrical connection may only be performed by a qualified electrician/ competent person. The electrical connection must be carried out in accordance with prevailing regulations for appliances using heavy current. The connection must comply with any specific requirements specified by the local electricity supply authority.
  • Page 15: Technical Data

    Two-phases zero-earth (max. 10A) Cable type 1 mm² HO5VV-F. The cable outside diameter must be between 7,5 and 10,5 mm. Technical data Cell Voltage 230 V Electrical connection 230/400 V 2 phases, neutral + earth Total wattage 6400W Instant heat effect 12/18 cm 1700 W Instant heat effect 21 cm 2300 W Instant heat effect 14 cm 1200 W This unit is...
  • Page 16: Warranty

    Check to see whether a fuse has by an alternative service organisation, blown. approved by the distributor. Only spare parts delivered by the distributor may Check to see whether the relay is be used. Spare parts and service are the switched off.