Electrolux EHP 601 K Operating And Assembly Instructions Manual

Ceramic glass hob
Hide thumbs


Quick Links

Ceramic Glass Hob
Operating and Assembly Instructions
EHP 601 K
319 5725-00
PE- - D



  Summary of Contents for Electrolux EHP 601 K

  • Page 1 Ceramic Glass Hob Operating and Assembly Instructions EHP 601 K 319 5725-00 PE- - D 2000.11.27...
  • Page 2: Dear Customer

    These instructions contain informations on how to rec- tify faults yourself. See the section “What to do if ... “ Should you require further assistance, please contact your local Service Force Centre. Customer Care Department Electrolux 55--77 High Street Slough Berkshire SL1 1DZ...
  • Page 3: Table Of Contents

    Content For the user Dear Customer Safety information Disposal of packaging material Hints of disposal Description of the hob Before the first use Cleaning for the first time Operating instructions General information Heat control knobs Residual heat indicator Application, charts, tips Cooking and frying utensils General hints Energy consumption...
  • Page 4: Important Safety Information

    Important Safety Information This information is provided in the interest of your safety. Please read it carefully before installing or using the hob. If your are unsure of any of these warning please contact our Customer Care Department on 08705 950950. Electrical safety This appliance must be installed by qualified personnel.
  • Page 5: Disposal

    Disposal Disposal of packaging material All parts of the packaging can be recycled and hard foam parts are appropriately marked. PE = Polyethylene (outer wrapping and the bag inside) PS = Polystyrene foam (eg. packing pieces) Please dispose of all packaing and old appliances with due regard for safety and the environment.
  • Page 6: Description Of The Hob

    Description of the hob Cooking Zone rear left Cooking Zone front left Before the first use Cleaning for the first time The hob has to be cleaned thouroughly before it is first used. Wash the ceramic glass surface and the frame with warm water with a little washing up liquid ad- ded and wipe dry.
  • Page 7: Operating Instructions

    Operating Instructions General information The cooking surface is made of proven ceramic glass and consists of 4 cooking zones. The rapid glowing cooking zones are especially efficient radiant heating elements which will considerably reduce the duration of heating--up. The cooking surface is insensitive to rapid chan- ges in temperature.
  • Page 8: Application, Charts, Tips

    Application, Charts, Tips Cooking and frying utensils The better the pot or the pan, the better the boiling or frying result. You can recognise good quality pans by their base. The base should be thick and as flat as pos- sible.
  • Page 9: Chart: Boiling And Frying

    wherever possible, cover pots and pans with a lid. never place pots or pans on cooking zones with a larger diameter. wet or dirty cooking zones and pots will waste energy. switch off the cooking zone a few minutes before the end of the cooking time, in order to make use of the residual heat.
  • Page 10: Cleaning And Care

    Cleaning and care Attention! Cleaners must not get onto the hot ce- ramic glass surface! After cleaning all residues of cleaners must be removed with sufficient clean water, as they may be caustic when being rehea- ted. Never use aggressive or abrasive agents, such as oven sprays, stain or rust removers, scouring powder, or sponges with an abrasive effect.
  • Page 11: Special Soilage

    Special soilage Sugar Remove burnt--on sugar, melted plastics, alumi- num foil immedeiately -- when they are still warm -- using a glass scraper, otherwise damage may be caused. Warning! When using the cleaning scraper on the warm cooking zone care should be taken. Afterwards clean the cooking surface normally.
  • Page 12: Installation Instructions

    Installation instructions Hints on safety This appliance must be installed and connec- ted by a qualified electrician or competent person. Please observe this instruction, otherwise the warranty will not cover any da- mage which may occur. During the installation and in case of a service fai- lure the appliance must not be connected to the mains.
  • Page 13: Hob Installation

    Hob installation Cut out the worktop according to the cutout size. The tolerances must not be exceeded. Precisely saw at the marked line. With tile--coated worktop areas any slits in the surface of the cooking area must be filled up com- pletely.
  • Page 14: Electrical Connection

    Electrical connections Before connecting the appliance, check that the voltage quoted on the rating plate - that is, the no- minal voltage of the appliance - corresponds to the available mains voltage. The rating plate can be found on the base of the ceramic glass hob. The mains connection must be carried out by an expert electrician.
  • Page 15: Technical Data

    The rating plate is not visible after the hob has been built--in. This information will be required: -- when requesting a service call -- when ordering spare parts or accessories -- with technical queries. EHP 601 K Modell Prod.Nr. PEE2 001 230 V AC 50 Hz...
  • Page 16: Something Not Working

    Discolourations appear in the cookin g zone If after carrying out the abovce checks there is still a fault, contact your local Electrolux Service Force Centre. Service and Spare Parts If you require an engineer or you wish to purchase...
  • Page 17: Guarantee Conditions

    Guarantee Conditions Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of fault workmanship or materials, we will, at our...
  • Page 20 Ó Electrolux Household Appliances Limited 2000 IBNr.319 5725-00 PE- -D 2000.11.27...