To Change The Light Bulb; When The Appliance Is Not In Use; Something Not Working - Electrolux EU7512C Instruction Booklet

Table of Contents

Advertisement

To Change the Light Bulb

The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Raise the lamp grille.
Use a bulb of the same type, E14 socket, maximum
rating of 25 W.
When replacing the light bulb, use a bulb of the
same type as the original one. The glass must
measure at least 18 mm in diameter at the socket.
This will ensure close fitting of the bulb against the
rubber seal in the socket.

When the appliance is not in use

Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.

Something Not Working

Before contacting your local Service Force Centre check the following point:
Problem
Audible alarm + flashing red warning
lamp. (It is too warm inside the freezer.)
It is too warm inside the freezer.
It is too cold inside the freezer.
Too much frost and ice are produced.
The compressor operates continuously.
The cabinet does not operate at all.
Cooling or interior light does not
operate. No indicator lamps light.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside
from spoiling in case of a power failure.
Possible cause / Remedy
Switch off the audible alarm by pressing the alarm shut-off
button.
The audible alarm could have been triggered by:
The cabinet having been recently switched on and the
temperature still being too high. See the chapter "Switching on
and setting the temperature".
Set a lower temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
The cabinet is not switched on.
Power does not reach the cabinet. (Try connecting another
electrical device to the power outlet.)
The fuse has blown.
The power plug is not properly connected.
8
GB
Electrolux 818 21 30-00/8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Erc3712sEr9098bsanEr9099bcre

Table of Contents