30 electrolux something not working
Malfunction
The machine fills then
empties immediately:
The machine does not
empty and/or does not spin:
There is water on the floor:
Unsatisfactory washing
results:
Possible cause
The end of the drain hose is
●
too low.
The drain hose is squashed
●
E20
or kinked.
The drain pump is clogged.
●
E20
The option
or
●
the
programme has
been selected.
The laundry is not evenly
●
distributed in the drum.
Too much detergent or
●
unsuitable detergent
(creates too much foam)
has been used.
Check whether there are
●
any leaks from one of the
inlet hose fittings. It is not
always easy to see this as
the water runs down the
hose; check to see if it is
damp.
The drain hose is damaged.
●
The cap on the emergency
●
emptying hose has not
been replaced after cleaning
the pump.
Too little detergent or
●
unsuitable detergent has
been used.
Stubborn stains have not
●
been treated prior to
washing.
The correct temperature
●
was not selected.
Excessive laundry load.
●
Solution
Refer to relevant paragraph
●
in "water drainage" section.
Check the drain hose
●
connection.
Clean the drain pump.
●
Select the option
or
●
.
Redistribute the laundry.
●
Reduce the detergent
●
quantity or use another one.
Check the water inlet hose
●
connection.
Change it with a new one.
●
Put the cap back on the
●
emergency emptying and
place the latter back in its
seat.
Increase the detergent
●
quantity or use another one.
Use commercial products to
●
treat the stubborn stains.
Check if you have selected
●
the correct temperature.
Introduce into the drum less
●
laundry.
,
or