GE SymVeo SV-XP1 User Manual page 19

Using the Web Browser to change the IP address
1. Enter the web browser and type in the new IP address of
the camera.
2. At the Password prompt, use admin for the user ID and
admin for the password (you can add users and change
passwords at any time).
3. Click on the Configure link on the main menu.
4. Click on the Network Settings link.
5. Enter the new IP, Subnet Mask and Gateway Addresses
6. Click Save, the camera will automatically reboot with the
new settings.
Note: If you change the IP address to a domain that is different from
your network, you will be unable to connect to the camera via the
web browser and you will need to perform subsequent changes to
the network settings with the RS232 cable or the On Screen Display
until you change the network settings back to the same domain as
your network.
PAL Installation
PAL installations require the exact sequence of events for correct
and full function of your SymVeo SV-XP1 camera. Please note
that after you follow this procedure, any subsequent changes of
the IP address can be done with any of the outlined methods.
1. Follow the Using the RS232 Cable instructions to set the
IP and other addresses for the unit.
2. Once the camera reboots with the new network address
settings, you should be able to access the camera via
Internet Explorer.
13