Setting The Network Addresses - GE SymVeo SV-XP1 User Manual

5. As an option connect the supplied RS232 cable to the
RS485 connector on the camera and a COM port on your
PC to configure you IP addresses.
Note: See the next section for instructions on how to set the network
address on your SymVeo camera.
Rear panel LEDs
Figure 5. Rear Panel LEDs
1. Power LED: Indicates power is on when glowing.
2. Ethernet LED: Indicates an ethernet connection.
3. 10 Mbps: Indicates a connection speed of 10 Mbps.
4. 100 Mbps: Indicates a connection speed of 100 Mbps.

Setting the Network Addresses

The SV-XP1 IP camera comes with preset Network addresses,
they are;
• IP address of 3.112.55.167
• Subnet mask of 255.255.254.0
• Gateway address of 3.112.54.1
9