KitchenAid Instant Hot Installation Instructions And Use And Care Manual page 7

NOTE: Do NOT plug power supply cord into outlet.
4
. Lay spout assembly on flat
surface with coiled tubing facing up.
tubing with other hand. Slide gasket
Using one hand to hold tubing just
over tubing so that lip side of gasket
is seated into base of spout.
below spout, carefully straighten
5
n Loosen square nut until it is
flush with end of the mounting screw.
Hold nut, bracket, gasket and tubing
in position and insert into hole in sink
Tip spout bracket against mounting
screw. (Bracket will form a "y" when
in the correct position.)
or counter.
6
.Pull up on spout body to keep
tension on spout mounting bracket
and nut. Tighten screw inside the
spout until spout is securely in
position. Do not overtighten. Snap
- on On/Off Cap.
7
.Position tank vertically beneath Position mounting bracket on wall so
spout so that clear tubing from spout that bottom of mounting bracket is
reaches center stainless tubing on even with the lower line. Use two
tank, and tank touches wall. Use a screws (and plastic anchors if
pencil to mark on the wall where the attaching to dry wall) to fasten
top of tank needs to be located. Set mounting bracket to wall. Hang tank
tank aside. Mark a second line 2-l/4" on bracket.
(5.7 cm) below the first line.