Dispenser - KitchenAid Instant Hot Installation Instructions And Use And Care Manual

13
.Connect water supply line from
saddle valve to spout copper tubing with
the factory-assembled quick-connect
fitting. Push water supply line tubing
straight into fitting as far as it will go. Pull
on tubing.
The tubing should not come out when
properly installed. Turn the saddle valve
handle counterclockwise C to open
water line.
NOTE: Do NOT plug power supply cord into outlet.
14
.Turn Temuerature Control
counterclockwise to "Off" position.
15
.Turn the On/Off Cau
clockwise to open spout. Hold cap
open to fill tank (about 1 minute).
When tank is full, water will flow from
spout. Release cap.
16
. Plug power supply cord into
grounded outlet.
Turn Temperature Control clockwise
to highest position.
Water in tank will reach maximum
temperature in approximately
15 minutes.
When water is heating, you may hear
gurgling noises coming from the tank.
There may also be some spitting or
hot water flow from the faucet. This is
normal for the initial heat-up of the
dispenser.
Turn Temperature Control to lower
temperature setting if you notice
vapor or hear boiling noise.
NOTE: Temperature Control
controls tank heater, not water
delivery. Rotate Temperature
Control clockwise to raise water
temperature, counterclockwise to
lower water temperature.
:;;;?; &&