Table of Contents
Advertisement
ZEM200WV
Tools and materials required:
In-wall
• 3/8" thick plywood (min.)
installation
• 2" x 4" lumber
• Saw
• Screws and screwdriver or other hardware for construction of
Opening for model ZEM200WV must be:
• 24 -7/8"
• 15"
• With approximately 1-1/4" for oven trim overlap
• Deep enough to accommodate electrical receptacle
• Height from floor may vary according to preference
Within opening of appropriate dimensions:
• Install a level base of plywood:
• 3/8" thick (min.) plywood must be supported by
• Finished floor must support a minimum of 100
• JX827WN accessory kit may be assembled and
The JX827WN accessory kit provides trim strips to
conceal all raw edges of cabinets.
plywood base.
1/16" wide.
1/16" high.
around all edges of opening.
and permit adequate air circulation for proper
venting:
– Minimum 18" deep with receptacle inside cutout.
– Minimum 16" deep with receptacle outside cutout.
of user.
Note:
kit will require wall space
26-1/8" W x 16-1/4" H for
clearance.
– Flush with lower edge of opening.
– Entirely covering floor of opening.
2" x 4" or 1" x 2" equivalent runners on all sides.
pounds.
installed at this time. Refer to "Installation" for
instructions.
Installation Preparation
When installed, trim
Microwave Oven
4
Advertisement
Table of Contents
