This appliance must be properly grounded. See “Electrical Supply”, page 6. CAUTION WARNING If you have questions concerning the installa- tion of this product, call the GE Answer Center® Consumer Information Service at 800.626.2000, 24 hours a day, 7 days a week. If you received a damaged microwave oven, you should contact your dealer.
To obtain ahead of time, order Pub. No. 31-1130 for Under Cabinet Installation. Order Pub. No. 31-1163 for Built-In Accessory Kit JX827. Call GE Publications: 800-848-7722. • 12" deep cabinet is preferred, though oven may be mounted on shallower cabinetry.
The JX827 accessory kit provides trim strips to conceal all raw edges of cabinets. 1/16" wide. Note: When installed, trim kit will require wall space 26-1/8" W x 16-1/4" H for clearance. Installation Preparation Microwave Oven 18" Min. Receptacle Inside 16" Min. Receptacle Outside 15" 1/16 24-7/8"...
90 pounds from the bottom. Refer to “Advance Planning” for more details. Installation Preparation Micr owav e Oven 24-7/8" 1/16" 15" 1/16" Per Oven Requirement Door Front of Cabinet Bracket Side of Microwave...
• Electrical cable, 2-wire with ground, No. 14 minimum, as required. Monogram microwave ovens require a 120 volt, 60 Hz power supply, protected by a time delay fuse or circuit breaker. These ovens are supplied with a power cord 40"...
• When cabinet depth is a critical factor, In-wall receptacle should be installed in a side wall installation at rear of opening: – 14-5/8" minimum cabinet depth is (continued) required. • If receptacle is located behind oven, install receptacle flush with wall to minimize depth: –16"...
Tools and materials JX827 required: installation • Accessory kit JX827 for in-wall installation • 2 Phillips head screwdrivers (#1 & #2) •Drill and 3/32" drill bit • Centerpunch or nail • Pencil and ruler JX827 Parts List 1. Base Pan 2.
Page 9
Install • Remove any protective film on oven cabinet. • Place the microwave oven on the base pan base pan centered left to right. Note: Do not tighten screws until all screws are started.
Page 10
Caution: Do not pinch power cord. • Plug the power cord into the wall receptacle. • Gently slide the microwave oven assembly into the cabinet opening, keeping it centered. • Push to the back, allowing tongues of rear brackets to slide through rear slots.
• Assemble top, Step 6 bottom and side Assemble trims with four screws D, as trim kit illustrated. frame When assembled, top, bottom and side strips must be flush. Note: Bottom trim has a hinge notch and is not interchangable with top trim. Step 7 Install trim kit...
Tools and materials Under-cabinet required: mounting • Flat-blade screwdriver • Phillips screwdriver • Drill and 1/4" bit • Nail or center punch • Pencil and ruler • Scissors • Hammer • Tape • Safety glasses • Two brackets (supplied) • Carefully remove the four plastic plug buttons from oven top and the two screws at top rear flange of case.
– Cut excess paper from center of Template 2 so it will lie flat. – Distance from right hole center to left hole center should measure distance indicated on template. – Tape remaining portion of Template 2 in place. Installation Microwave Oven...
• From inside cabinet, insert four bolts, all same length, through mounting straps and then into drilled holes of cabinet shelf. Front of Cabinet Bracket Side of Microwave...
Page 16
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. To obtain specific information concerning any Monogram product or service, call GE Answer Center consumer information service at 800.626.2000—any time, day or night. For Monogram local service in your area, call 1-800-444-1845.
Need help?
Do you have a question about the Monogram ZEM200BF and is the answer not in the manual?
Questions and answers