GE Monogram ZEM200 Series Installation Instructions Manual
Under cabinet installation and jx827 series built-in kit
Hide thumbs
Also See for Monogram ZEM200 Series:
- Owner's manual (28 pages) ,
- Installation instructions manual (16 pages) ,
- Owner's manual (28 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Advertisement
Table of Contents
Related Manuals for GE Monogram ZEM200 Series
Summary of Contents for GE Monogram ZEM200 Series
- Page 1 GE Monogram ® Installation Instructions Under Cabinet Installation JX827 Series Built-In Microwave Oven Models ZEM£O0 Series...
-
Page 2: Table Of Contents
If you have questions concerning the installa- installer. Product failure due to improper tion of this product, call the GE Answer Center® Consumer Information Service installation is not covered under 800.626.2000, Appliance Warranty. See the Use & Care hours a day, 7 days a week. -
Page 3: Model Available
Installation. Order cooktop, range or other heating surface. Pub. No. 31-1163 for Built-In Accessory JX827. Call GE Publications: 800-848-7722. Refer to "hrstallation" for complete details • 12" deep cabinet is preferred, though oven preparation for in-wall installation. may be mounted on shallower cabinetry. -
Page 4: In-Wall
Installation Preparation Microwave Oven In-wall Tools and materials required: 18" Min. • 3/8" thick plywood (min.) installation Receptacle • 2" x 4'r lumber Inside • Saw Receptacle • Screws and screwdriver or other hardware for construction of Outside plywood base, The opening must •... -
Page 5: Under-Cabinet
Installation Preparation Microwave Oven Refer to diagram With single right for dimensions 0 ven when installing above a Monogram single oven. Requirement Within opening of appropriate dimensions: • Install a level base of plywood: - Flush with lower edge of opening. -Entirely covering floor... -
Page 6: Installation
Installation Preparation Microwave Oven Electrical Tools and materials required: • 3-prong grounded electrical receptacle supply • Electricalcable, 2-wire with ground, No 14 minimum, as required Monogram microwave ovens require a 120 volt, 60 Hz power supply, protected by a time delay fuse or circuit... -
Page 7: Under-Cabinet
Installation Preparation Microwave Oven In-wall • When cabinet depth is a critical factor, receptacle should be installed in a side wall installation at rear of opening: 14-5/8" nlininmm cabinet depth (continued) requ ired. Receptacle installed in side wall, • If receptacle is located behind oven,... - Page 8 Installation MJ('I'O Oven Toolsandmaterials JX8 2 7 required: installation • AccessorykitJX827for in-wallinstallation • 2Phillipsheadscrewdrivers (#1 & #2) • Drilland3/32"drill bit • Centerpunch or nail • Pencil a ndruler JX827 Parts List 1. BasePan Parts Inventory 2. Rear Duct 3. Side Covers (2) 4.
- Page 9 Installation Microwave Oven Step 2 • Remove tile four top plug buttons fl'om the top of the microwave oven cabinet. Remove 4 PlugButtons Install • Remove any protective fihn on oven cabinet. • Place the microwave oven on the base pan base pan centered left to right.
- Page 10 Installation Microwave Oven Screws RearDuct Step 4 Install rear duct Screw C -%ceScrew Partition BasePan in BasePan • Drive one screw into the rear duct side • Install rear duct by inserting into bottom flange neat" the lamp cover. flange between oven back...
- Page 11 Installation Microwave Oveo • Assemble top, Step 6 Screw TopTrim bottom and side Assemble trims with four D, as trim Mt screws Screw D illustrated. frame Screw When assembled, %,:.. top, bottom aird side strips must be flush. SideTrim Screw Note: Bottom trim has a hinge notch and is not interchangable with top trim.
-
Page 12: Installation
Installation Microwave Oven Tools and materials Under-cabinet Buttons required: m o un ting • Flat-blade screwdriver • Phillips screwdriver • Drill and 1/4" bit • Nail or center punch Embos ght Side Case s%Ri • Pencil and ruler • Scissors •... -
Page 13: Installation
Installation Microwave Oven To drill -Position remaining piece of Template 2 inside cabinet align hole center line with arrows from inside on Template Cut excess paper from center of Template 2 so (continued) it will lie flat. -Distance fl'om right hole center to left hole center... -
Page 14: Finalize Under-Cabinet Installation
Installation Microwave Oven Finalize under-cabinet installation D°°r_,_nt of Cabinet Bracket 3_l__d A_Top of BottomShelf Sideof Microwave With template secured in place, check again Remove template and clean drill holes. • Select four bolts--one of each size--fl'om that hole center lines on Template 2 are straight, and that distance... - Page 15 Notes Microwave Ovens...
- Page 16 NO'I E: Product impvovelnent is a contin_lil_g endeavor at General EJ_ctlic rhe_'efore, inat_rials, al_pearanc_ al_d s]_cifications Pub No 49 8893 stfl_iecl to change witho_t i_olice Pair No 164D3333P128 Monogram; ', 1997 GE Al_pliances 881) 10/97 General Electric Company Lr._lfsvifle, KY40225...