Operating Instructions - GE Monogram ZDI15 Owner's Manual

How your
When you first start your icemaker, the water
icemaker reservoir will fill and the system will rinse itself
before starting to make ice. The rinsing
works
process takes about five minutes.
Under normal operating conditions, the
icemaker will cycle at preset temperatures.
The ice level sensor located in the ice storage
bin will monitor the ice levels.
IMPORTANT
• If the water supply to the icemaker is
• Every time the icemaker is turned off, you
• The icemaker is designed to make clear ice
Making Ice
1. Water is constantly circulated over a freezing
10
turned off, be sure to set the icemaker
control to OFF. Drain the water reservoir
and leave the icemaker door open to allow
it to dry completely.
MUST clean the icemaker system with Nickel
Safe Ice Machine Cleaner. See Care and
Cleaning—Icemaker system section for instructions.
from the majority of water sources on a daily
basis. If your results are unsatisfactory, your
water may need to be filtered or treated.
plate. As the water freezes into ice, the
minerals in the water are rejected. This
produces a clear sheet of ice with a low
mineral content.

Operating Instructions

Icemaker
2. When the desired thickness is reached, the
ice sheet is released and slides onto a cutter
grid. The grid divides the sheet into
individual cubes.
3. The water containing the rejected minerals
is drained after each freezing cycle.
4. Fresh water enters the machine for the next
ice making cycle.
5. Cubes fall into the storage bin. When
the bin is full, the icemaker shuts off
automatically and restarts when more ice
is needed. The ice bin is not refrigerated
and some melting will occur. The amount
of melting varies with room temperature.
NOTE: As the room and water temperatures
vary, so will the amount of ice produced and
stored. This means that higher operating
temperatures result in reduced ice production.