Manufacturers' Code Settings - Panasonic TX-76PW05A Operating Instructions Manual

Remote Control VCR/LD/DVD Operation

Manufacturers' Code Settings

This remote control has been designed to work with a variety of VCRs, Laser Disc players and DVD players.
In order for this to occur, the setting for the VCR, LD or DVD must be programmed into the Remote Control.
1. To set a VCR, slide the remote control VCR-LD/DVD switch
To set a LD or DVD, slide the remote control VCR-LD/DVD switch
2. Push the remote control VCR - LD/DVD Power Button
3. Enter the Manufacturer's two-digit code number using the remote control Number Buttons
(The codes are shown below).
4. Push the STOP button
5. Release the remote control VCR or LD/DVD Power Button
6. Check the operation of the VCR, LD or DVD. If it does not operate correctly, repeat steps 1 to 5 and
use an alternate code (if there is one).
VCR CODES
Manufacturer
Panasonic /
National
AIWA
FUJITSU
HITACHI
JVC
MITSUBISHI
LD CODES
Manufacturer
Panasonic
KENWOOD
PHILIPS
PIONEER
DVD CODES
Manufacturer
Panasonic
NOTES:
1. If the batteries are removed from the remote control the Manufacturer's codes are lost and must be
reprogrammed.
2. The list of manufacturer's codes is given as a guideline only. Panasonic cannot guarantee that any
other manufacturer's product will work with this remote control.
34
.
Code
10, 11, 12, 13
15, 16
20
25, 26, 27
30, 31, 32
35, 36
Code
10, 11, 12, 13
15, 16
20
25
Code
70
to VCR.
to LD/DVD.
and keep it Pushed.
.
Manufacturer
NEC
ORION
Philips
SANYO
SHARP
SONY
TOSHIBA
Manufacturer
SAMSUNG
SHARP
SONY
Code
40, 41, 42, 43
45, 46
50
55, 56, 57, 58
60, 61
65, 66, 67
70, 71
Code
30
35
40, 41, 42, 43