Abit SI-2P+ User Manual page 38

3-4 Chapter 3
Cylinder
This item configures the numbers of cylinders.
Head
This item configures the numbers of read/write heads.
Precomp
This item displays the number of cylinders at which to change the write timing.
Landing Zone
This item displays the number of cylinders specified as the landing zone for the
read/write heads.
Sector
This item configures the numbers of sectors per track.
Drive A
This item sets the type of floppy drives installed.
[None]: No floppy drive installed
[360K, 5.25 in.]: 5.25-inch standard drive; 360KB capacity
[1.2M, 5.25 in.]: 5.25-inch AT-type high-density drive; 1.2MB capacity
[720K, 3.5 in.]: 3.5-inch double-sided drive; 720KB capacity
[1.44M, 3.5 in.]: 3.5-inch double-sided drive; 1.44MB capacity
[2.88M, 3.5 in.]: 3.5-inch double-sided drive; 2.88MB capacity
Halt On
This item determines whether the system stops if an error is detected during system
boot-up.
[All Errors]: The system-boot will stop whenever the BIOS detect a non-fatal error.
[No Errors]: The system-boot will not stop for any error detected.
[All, But Keyboard]: The system-boot will stop for all errors but keyboard error.
[All, But Diskette]: The system-boot will stop for all errors but disk error.
[All, But Disk/Key]: The system boot will stop for all errors but disk or keyboard
error.
SI-2P+