GE Monogram ZBD3500 Use And Care Manual page 10

THE DISPLAY TELLS YOU IF CERTAIN
DISPLAY WHAT IT MEANS
Electrical power to the dishwasher
has been interrupted but is now
back on.
RESET
Slow draining. The dishwasher is
taking longer than normal to drain
the water out. This is usually caused
by a blockage in the drain air gap
(see Air Gap section), a kink in the
drain hose, or a stopped-up pipe.
Drain is blocked. Similar to slow
drain. This indicates that the drain
is so clogged that the dishwasher
RESET
cannot continue to operate in a
satisfactory manner. Dishwasher
will stop.
Drain sensor is not functioning.
Dishwasher will continue cycle
along with a fixed drain period.
There is too much water in
the dishwasher.
RESET
10
THINGS ARE WRONG
WHAT TO DO
IF DISHWASHER WAS IN USE WHEN THE POWER
FAILURE OCCURRED:
1. Press the RESET pad and wait approximately 30 seconds.
2. Unlatch and open the door.
A) If the detergent cup is open and empty and the
B) If the detergent cup is closed and the dishwasher was set
C) If the dishwasher was set for the RINSE HOLD cycle,
IF THE DISHWASHER WAS NOT IN USE when power
failure occurred, use dishwasher as you normally would.
This dishwasher is designed to automatically compensate
for longer than normal drain times, but cycle time will be
extended. If this code continues to appear frequently:
1. Clean the air gap (See Air Gap section).
2. Check for a kink in the drain hose.
3. Check plumbing for slow or stopped-up drains. (NOTE:
Warranty service does not cover household drain problems.)
Press the RESET pad to stop the beep.
Locate and remove the blockage in the drain system.
To pump any remaining water out of the machine:
1. Latch door.
2. Select any cycle.
3. Touch "START" and then immediately touch RESET.
(NOTE: Warranty service does not cover household
drain problems.)
If
Press the RESET pad to stop the beep.
The dishwasher is designed to automatically pump out
extra water as long as the door is latched. When you hear
the motor stop running:
1. Unlatch the door and see if all the water is gone.
2. If you see water entering the dishwasher, close and latch
the door. Shut off the water supply to the dishwasher.
3. If water is gone and no water is entering the dishwasher,
restart cycle.
4. If
dishwasher. Call for service.
dishwasher was set for the NORMAL, POTS PANS
or CHINA CRYSTAL cycle, close door and put the
load through a RINSE HOLD cycle. After the RINSE
HOLD cycle is completed, add detergent and reset the
load for the washing cycle you want.
for the NORMAL, POTS PANS or CHINA CRYSTAL
cycle, reset the dishwasher for the wash cycle you want.
reset the dishwasher for RINSE HOLD.
repeats for the next cycle, call for service.
repeats, shut off the water supply to the