Miele KM 406 Operating Instructions Manual page 13

The control is used to switch on the
burner and regulate the strength of the
flame.
^ Press in the control and then turn
anti-clockwise to the large flame sym-
bol.
^ When the flame ignites, keep the
control pressed in for 8-10 seconds,
and then let it go.
If the flame goes out, repeat the proce-
dure, keeping the control pressed in for
a few extra seconds.
^ To turn the heat down from a high to
a low setting turn the control
anti-clockwise until there is a resis-
tance. Briefly press to turn past the
resistance. Then without pressing it in
turn the control to the required set-
ting.
^ To turn the heat up from a low to a
high setting, turn the control clock-
wise until there is a resistance.
Briefly press to turn past the resis-
tance. Then without pressing it in turn
the control to the required setting.
^ Turn the control clockwise until "ß" is
reached.
This stops the flow of gas and the flame
goes out.
Remember: Turn anti-clockwise to
switch on, turn clockwise to switch
off.
Stop when you feel a resistance. Do
not try to force the control further.
The control cannot be turned
anti-clockwise from the small flame
symbol to the "ß" position.
13