Trouble Shooting - Farenheit Car Multimedia System Operating Manual

TROUBLE SHOOTING

If any of problem persists after checking the below list, Please consult your
nearest service dealer.
Never attempt to disassemble and repair unit personally.
Problem
GENERAL
Unit will not power
on
Remote control
does not work
No/low audio
output
Poor sound quality
or distortion
Unit resets itself
when engine is off
TUNER
Weak station
searching
TFT MONITOR
No image
Flashing image or
interference
appears on screen
Prolonged image
or improper
height/width ratio
display
Cause
ACC Fuse blown
Car battery fuse blown
illegal operation
Battery depleted
Battery installed incorrectly
Improper audio output
connection Volume set too low
Speakers damaged
Heavily biased volume balance
Speakers wiring is in contact
with metal Part or car
Pirate disc is in use
Speaker power rating not
compatible with unit
Speaker is shorted
Incorrect connection between
ACC and Positive battery wire
Auto antenna is not fully
extended
Auto antenna not properly
connected LOCAL function is
activated
Incorrect connection to parking
brake wire PARKING
activated and parking brake is
not engaged
DVD is not compatible with
current TV system
Image blurred, distorted, or dark
Improper video
connections Improper
ratio setup
- 42 -
Corrective Action
Install new fuse with correct rating
Install new fuse with correct rating
Press the RESET button located in
the bottom right
corner of the front panel
Replace battery with new one
Remove battery and install correctly
Check wiring and correct
Increase volume level
Review wiring diagram and check
MUTE connection Replace speakers
Adjust the channel balance to the
center position Insulate all speaker
wiring connections
Use original copy
Connect proper speakers
Check speaker contact
Check wiring and correct
Connect the auto antenna control
cable properly Connect the auto
antenna control cable properly Turn
LOCAL function off
Check wiring and correct
is Stop vehicle in safe place and apply
parking brake
Change setup to accommodate disc
settings
signal Check wiring and correct
aspect Use correct aspect ratio setting