Laser Product - Kenwood KDC-MP443 Instruction Manual

Menu Glossary
• SWPRE (Switching Preout)
Switches the preout between rear output ("R") and
subwoofer output ("SW").
• SPRM (Supreme)
Technology to extrapolate and supplement with
proprietary algorithm, the high-frequency range
that is cut off when encoding at low bit rate.
Supplementing is optimized by compression
format (MP3 or WMA) and processed according to
bit rate.
The effect is negligible with music that is encoded
at high bit rate, variable bit rate or has minimal high
frequency range.
• CD READ
Sets the method for reading CD.
When unable to play special format CD, set this
function to "2" to force playing. Note that some
music CD may be unplayable even when set to "2".
In addition, audio files cannot be played when set
to "2". Normally, keep this set to "1".
1 : Automatically distinguishes between audio file
disc and music CD when playing disc.
2 : Forces playing as music CD.
• AUX
When this is set to ON, AUX source can be selected.
ON1: Outputs the sound of external unit connected
to the AUX terminal when switched to AUX
source.
ON2: Activates the attenuator function when
switched to AUX source.
Turn off the attenuator function when
listening to output from external unit. This
prevents the noise when no external unit is
connected to AUX terminal.
OFF: Disables the selection of AUX source.
Set to OFF when not using the AUX terminal.
• AUTO1, AUTO2, MANUAL (Tuning mode select)
Select a tuning mode of the radio.
Tuning mode Display
Auto seek "AUTO1"
Preset station seek "AUTO2"
Manual "MANUAL" Normal manual tuning control.
• LO.S
When this function is turned on the auto seek
turning automatically searches for station with
good reception.
It is especially useful searching station with SW1
band or SW2 band.
Operation
Automatic search for a station.
Search in order of the stations in the
Preset memory.
• ICON
Sets the Graphics mode of the display during
normal playback condition.
ON1: Turns on.
ON2: Displays an animation.
OFF: Turns off.
The marking of products using lasers
(Except for some areas)
CLASS 1

LASER PRODUCT

The label is attached to the chassis/case and says
that the component uses laser beams that have
been classified as Class 1. This means that the unit is
utilizing laser beams that are of a weaker class. There
is no danger of hazardous radiation outside the unit.
15
|
English