MULTIQUIP WHISPERWATT DCA-15SPXU4 Operation Manual page 23

DCA-15SPXU4 — OUTPUT TERMINAL PANEL FAMILIARIZATION
120 VAC GFCI Receptacle
This120 VAC, 20 amp GFCI (Duplex Nema 5-20R) receptacle
can be used anytime the generator is in operation. Remember
the load output (current) of the GFCI receptacle is dependent
on the load requirements of the U, N, and V output terminal
lugs.
Pressing the reset button resets the GFCI receptacle after
being tripped. Pressing the Test Button (See Figure 6) in
the center of the receptacle will check the GFCI function.
Both receptacles should be tested at least once a month.
Figure 6. G.F.C.I. Receptacle
Twist Lock Dual Voltage 120/240 VAC Receptacle (Option)
There is one CS-6369 120/240V, 50 amp auxilliary twist-lock
receptacle (Figure 7) provided on the output terminal panel.
This receptacle is protected by a 50 amp circuit breaker.
TWIST-LOCK
RECEPTACLE
SINGLE-PHASE
50 AMP OUTPUT
Figure 7. 120/240V CS6369 Twist-Lock
Auxiliary Receptacle
DCA-15SPXU4— OPERATION MANUAL — REV. #0 (03/31/11) — PAGE 23
CS-6369
120/240 VAC
L5-30R Twist Lock 120 VAC Receptacle
There is one L5-30R, 120 VAC 30 amp auxilliary twist-lock
receptacle (Figure 8) provided on the output terminal panel.
Figure 8. 120 VAC L5-30R Twist-Lock
Auxiliary Receptacle
L6-30R Twist Lock 240 VAC Receptacle (Option)
There is one L6-30R, 240 VAC 30 amp auxilliary twist-lock
receptacle (Figure 9) provided on the output terminal panel.
Figure 9. 240 VAC L6-30R Twist-Lock
Auxiliary Receptacle
Turn the voltage regulator control knob (Figure 10) on the
control panel to obtain the desired voltage. Turning the knob
clockwise will increase the voltage, turning the knob counter-
clockwise will decrease the voltage.
Figure 10. Voltage Regulator Control Knob
1