Table of Contents
Advertisement
•
Run up the jam nut of the rear side until it touches
and then back off one turn.
•
Tighten the front side jam nut.
•
Check the brake pedal by hand. It should have 3/4"
free travel.
•
Hook up the return spring.
•
Rotate the rear wheels by hand with brake pedal
released. The wheels should rotate freely.
•
Cautiously complete the testing on level ground by
operating the machine and applying brakes in a
normal manner.
•
Repeat the adjustment procedure if necessary.
Cleaning
The body panels are scratch and impact resistant
automotive quality ABS plastic. The use of standard car
wash soap and non-abrasive car wax is acceptable for
cleaning the body panels. Avoid any abrasive cleaner
or rubbing compounds for these will damage the body
panels. Dry thoroughly to avoid water spots.
WARNING: Damage may occur if direct hose
spray comes in contact with any other electri-
cal components, i.e. at instrument cluster or
under dash.
Storage
•
Stop the vehicle on a level surface and apply
parking brake.
•
Allow vehicle to cool.
•
Replace all worn, damaged, or missing parts and
tighten loose hardware as needed.
SECTION 5: SERVICE CHART
Check Transaxle Oil
Change Transaxle Oil
Tighten Wheel Bolts
Check Drive Belt
Grease Front Steering Spindle
Check Interlock Switch System
Replace Interlock Switch
# Change at the first 50 hours then again at 500 hours.
•
Wash the vehicle and clean inside the engine
compartment and under the cargo box.
•
Run engine for several minutes to dry belts,
pulleys, and other moving parts.
•
Clean and polish metal and plastic surfaces.
•
Apply light coat of oil to pivot and wear points to
prevent rust.
•
Lubricate grease points.
•
Replace fuel filter if needed. See engine manual.
•
Change engine oil and filter. See engine manual.
•
Drain all old fuel from tank.
Prepare fuel system for storage.
If planning to store vehicle with fuel tank empty:
•
Add a small quantity of fresh stabilized fuel to tank.
Run engine until it runs out of fuel. This will circulate
fuel mixture through engine.
If planning to store vehicle with fuel in the tank:
•
Fill tank completely with fresh stabilized fuel to
prevent condensation build-up. Run engine for
several minutes to circulate fuel mixture through
engine.
•
Turn the ignition key to the STOP position and
remove the key.
•
Remove and clean battery. See Battery in Service
Section.
•
Store battery in a cool, dry place. Fully charge
battery periodically during storage to maintain its
longevity.
•
Support vehicle safely on blocks or stands to take
weight off tires. Reduce 1/3 air from tires.
•
Cover vehicle with waterproof cover if stored
outside.
Before
First
Each
10 Hours
50 Hours
Use
16
Every
Every
100 Hours
or 2 years
#
Every
500 Hrs
Hide quick links:
Advertisement
Table of Contents
