Jandy FHPM FloPro Series Installation And Operation Manual page 5

FloPro Series Pumps Installation and Operation Manual
To minimize the risk of severe injury or death, the filter and/or pump should not be subjected to the
piping system pressurization test.
Local codes may require the pool piping system to be subjected to a pressure test. These requirements
are generally not intended to apply to the pool equipment, such as filters or pumps.
Jandy pool equipment is pressure tested at the factory.
However, if the WARNING cannot be followed and pressure testing of the piping system must include
the filter and/or pump, BE SURE TO COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS:
• Check all clamps, bolts, lids, lock rings, and system accessories to make sure they are properly
installed and secured before testing.
• RELEASE ALL AIR in the system before testing.
• Water pressure for test must NOT EXCEED 35 PSI.
• Water temperature for test must NOT EXCEED 100°F (38°C).
• Limit test to 24 hours. After test, visually check the system to make sure it is ready for operation.
Notice: These parameters apply to Jandy equipment only. For non-Jandy equipment, consult the
equipment manufacturer.
Chemical spills and fumes can weaken pool/spa equipment. Corrosion can cause filters and other
equipment to fail, resulting in severe personal injury or property damage. Do not store pool chemicals
near your equipment.
Do not start pump dry! Running the pump dry for any length of time will cause severe damage and will
void the warranty.
This pump is for use with permanently installed pools and may also be used with hot tubs and spas, if so
marked. Do not use with storable pools. A permanently installed pool is constructed in or on the ground
or in a building such that it cannot be readily disassembled for storage. A storable pool is constructed so
that it may be readily disassembled for storage and reassembled to its orig i nal integrity.
Do not install within an outdoor enclosure or beneath the skirt of a hot tub or portable spa. The
pump requires adequate ventilation to maintain air temperature at less than the maximum ambient
temperature rating listed on the motor rating plate.
WARNING
WARNING
CAUTION
CAUTION
CAUTION
SAVE THESE INSTRUCTIONS
Page 5