GE Powervent AP13787 Use And Care Manual page 30

Gas Valve LED Error Codes
1 1 s s t t F F l l a a s s h h , , 2 2 n n d d F F l l a a s s h h , ,
P P a a u u s s e e 1 1 P P a a u u s s e e 3 3
s s e e c c o o n n d d s s e e c c o o n n d d s s
Slow Flash
Fast Flash
1 Flash 1 Flash
2 Flashes 1 Flash
2 Flashes 3 Flashes
3 Flashes 1 Flash
3 Flashes 3 Flash
4 Flashes 1 Flash
4 Flashes 2 Flash
4 Flashes 3 Flash
5 Flashes
LED Steady ON
CAUTION: Make certain power to water heater is "OFF" before removing protective cover FOR ANY REASON.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous
operation. VERIFY PROPER OPERATION AFTER SERVICING.
CAUTION: For your safety DO NOT attempt repair of gas piping, remote control, burners, vent connectors or other safety
devices. Refer repairs to qualified service personnel.
30
P P o o s s s s i i b b l l e e C C a a u u s s e e s s
Normal operation.
N/A
Standby Mode.
Normal operation.
N/A
Heat Mode.
Lockout condition.
Ignition Failure.
Lockout condition.
Flammable Vapors Present.
Lockout condition.
FVD Interface Failure/Miswiring
(Flammable Vapor Sensor Failure).
Lockout condition.
Pressure Switch Fails to Open.
Lockout condition.
Pressure Switch Fails to Close.
Lockout condition.
Line/Neutral Polarity Failure.
Lockout condition.
ECO Failure.
Lockout condition.
False Flame (Unwanted Flame
Present).
Vacation Mode Active
-
Lockout condition.
N/A
System Error, Cycle Power.
W W h h a a t t T T o o D D o o
●
No problem.
●
No problem.
●
Third failed ignition attempt. Unplug to reset
control. Contact qualified service technician.
●
Make sure manual gas shutoff valve is open.
●
If pressure is too high, the valve will not
operate.
l● Clean any scale buildup from burner and pilot
assembly. (Refer to page 26)
●
The spark ignitor assembly could be damaged
or broken. If so, replace assembly.
●
Bleed air from gas line. (Refer to page 28)
●
Contact local qualified service technician.
●
Contact local qualified service technician.
●
Contact local qualified service technician.
●
Contact local qualified service agent.
Inspect vent pipe and dilution air inlet for
blockage. (Refer to "Routine Preventive
Maintenance" Section.)
●
Check the electrical supply outlet.
●
Contact local qualified service technician.
●
Unplug to restart control. Contact local
qualified service technician.
●
Select desired temperature setting.
●
Contact local qualified service technician.