Storing Channels On The Vcr - Toshiba W522CG Owner's Manual

PREPARATION

Storing Channels on the VCR

This section is required if you receive only normal TV or unscrambled cable channels.
Incoming Antenna/Cable(CATV) Signals
The VCR scans through all receivable TV and CATV channels and stores only the active
ones in your area into the memory. Once the storing is finished, you can select a desired
channel using CH/TRK.
Preparation
• Turn on the TV, and select the video channel (3 or 4) or the video input mode if you made the Audio/Video
connection (page 11).
• Press I.SELECT so that the channel number will appear if "L" is displayed in the VCR display.
VCR TV
POWER
1 2 3
Number
buttons
4 5 6
CM SKIP
7 8 9
A.SELECT
100
0 100
REW
EJECT
PLAY
FF
REW F F
ENTER
PLAY, STOP
STOP
SLOW PAUSE/STILL
REMAIN/ COUNT
DISPLAY SP/ SLP
COUNTER RESET
ENTER
REC TIMER
I.SELECT
TV VOL PROG. CANCEL
1,6
I.SELECT
16
W522CG ENG new (10-19)
Incoming Antenna/Cable(CATV) Signals
1
Press PROG. to display the MENU screen.
2
Select "PRESET" using FF or REW,
and press ENTER.
3
Select "CH MEMORY" using PLAY
or STOP, and press ENTER.
4
Set "TV/CATV" to "TV" or "CATV" using FF or REW.
TV: To store channels received via the antenna.
CATV: To store channels received via the incoming cable.
5
Select "AUTO SCAN" using PLAY or
STOP, and press FF to set to "ON".
The VCR starts scanning and the
channels are stored in the VCR in
ascending order. When the scanning is
finished, the screen automatically
returns.
6
Press PROG . twice to exit.
16 2/20/04, 11:17