Kawai Concert Artis CA61 Owner's Manual page 83

4. Adjusting the pedal support
Turn the pedal support (C) at the bottom of the stand until it reaches the
fl oor.
The pedal stand may be damaged if the pedals are
Caution
used when the pedal support is not touching the fl oor.
Make sure that the pedal support is touching the
fl oor.
Once the pedal support touches the floor, stop
turning it. Failure to do so may result in damage to the
stand.
When you move the unit, remove the pedal support
before moving. Readjust the pedal support after
moving is complete.
5. Attaching the back panel
(1) Place the pedal cord and speaker cord in the gap between the piano
and the stand.
(2) Fasten the back panel with two screws B (M4 x 16).
Make sure that all the screws have been properly
Caution
tightened.
6. Connecting the power cord
Connect the power cord to the piano.
Power cord
Use the cord clamp to secure the power cord so that
Caution
the cord will not touch the sound board. Noises may
be generated if the power cord touches the sound
board.
7. Attaching the score stand.
8. Remove the protective plastic fi lm on the display.
Display
Attaching the headphone hook
Using two screws with a sharp end (M4 x 14) that come with the headphone
hook, you can attach the headphone hook beside the headphone jack.
* This step is optional. If you do not need the hook, keep it with the
instruction manual.
Headphone jack
Caution
Screws with a fl at end
B. M4 x 16
Sound board
Assembly is now complete
Headphone hook
Screws for attaching
the headphone hook
<When moving the unit>
When you move the unit, make sure to remove the
end panels and the pedal support before moving.
Do not drag the unit.
When you remove the piano from the stand, fi rst
disconnect the pedal cord, speaker cord, and power
cord.
<Sound board at the back of the stand>
Natural wood is used on the surface of the sound
board, and its color may be therefore different from
the artifi cial panel color.
Page
83
Score stand
10