Weber Skyline 3200 LP Owner's Manual page 19

Step 17
Install the lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair pin
cotters into the small holes in the hinge pins. Figure 23.
Hair pin cotter
Hinge pin
Figure 23
Step 18
Install control panel and burner control knobs
You will need: control panel, two Phillips screws/washers,
a Phillips screwdriver, and three burner control knobs.
Set the control panel in place over both frame braces. (Hold
the Crossover Ignition button up while setting the control
panel in place.) Line up the holes in the control panel with
the holes in the inserts in the frame brace. Insert screws
and tighten with a Phillips screwdriver until snug. Do not
overtighten. Figure 24 (a).
Push on the burner control knobs. Figure 24 (b).
Insert in
frame brace
Crossover
Ignition
Button
Figure 24
19
(a)
Control panel
Phillips screws/
washers
(b)