Weber Skyline 3200 LP Owner's Manual page 12

Step 7
Install side burner locks
Note: The locks are taped to the inside of the side
burner lid.
You will need: frame assembly, two side burner locks and
a 7/16 inch wrench.
Turn frame assembly right side up.
Loosen the right rear 1/4 x 20 bolt. Install the side burner
lock. The "U" shape cut out of the lock slips down over the
bolt. Tighten with a wrench. Figure 6 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock
fits between the front panel and the frame. The "U" shape
cut out slips up over the bolt. Tighten with a wrench.
Figure 6 (b).
Figure 6
(a)
(b)
Step 8
Add cooking box
You will need: frame assembly, cooking box assembly,
1/4-20 x 2 inch bolt, nylon washer, 1/4-20 acorn nut, pliers
and a 7/16 inch wrench.
Set the cooking box into the frame so the burner tubes are
under the frame brace. Figure 7.
Slide the cooking box to the left within the frame. Put the
washer on the bolt. Take the spacer bracket and hold it
up to the frame making sure both tabs fit underneath the
frame cross piece. Figure 8 (a). Insert the bolt through
the center hole in the spacer bracket, frame and cooking
box with the head of the bolt outside the spacer bracket.
Figure 8 (b). Add keps nut. Tighten by holding the bolt with
pliers while you tighten the nut with the 7/16 inch wrench.
Keps nut
Bolt
Nylon
washer
12
Burner tubes
Frame brace
Figure 7
Frame cross
piece
Spacer
bracket
Figure 8
Tab