SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should
be in the OFF position. Figure 17 (a).
Make sure black wire is connected between igniter and
electrode. Make sure white wire is connected between
igniter and ground. Check that igniter lock nut is tight.
Figure 17 (b) and figure 17 (c).
Note - If the igniter works loose, carefully tighten the
igniter lock nut with an adjustable wrench or pliers.
(a)
burner control
Figure 17
white wire
Igniter button
knob
(b)
Igniter lock nut
Views of
figures 17 (b) and (c)
from under side burner
(c)
Ground
black wire
The Platinum Series II side burner has been factory set
for the correct air and gas mixture. The correct flame
pattern is shown in Figure 18.
electrode
16
Tips occasionally yellowish
Dark
blue
Figure 18
Light
blue