Control Knobs - Weber Genesis 2000 LP Owner's Manual

Step 16
Install the lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place from the rear of the barbecue. Close
and align the hinge at the rear. Insert hinge pins from the
outside through the hinge. Insert hair pin cotters into the
small holes in the hinge pins. Figure 21.
Figure 21
Hair pin cotter
Hinge pin
Step 17
Install tool holders, control panel and burner

control knobs

You will need: three tool holders, control panel and three
burner control knobs.
Hook the tool holders over the frame rail. Figure 22.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Place your thumbs over the
control panel push-in buttons and push them into the
frame brace until they snap into place. Figure 22 (a).
Push on the burner control knobs. Figure 22 (b).
Hole in frame brace
Tool holders
Figure 22
17
(a)
Control panel
push-in buttons
(b)