Advertisement
WLAN Setup with WPS
This section applies to the P-870HW Series only.
You can use Wi-Fi Protected Setup (WPS) to set up
a secure wireless network and add wireless devices
to your wireless network at the touch of a button.
The other wireless devices must also support WPS.
Look for the WPS logo on the housing of your device.
1. Place a WPS-enabled device within range of the P-870HW Series.
2. Press the WPS WLAN ON/OFF button (
for five seconds. Press the WPS button on another WPS-enabled
device. It doesn't matter which button is pressed first. You must press
the second button within two minutes of pressing the first one.
Your P-870HW Series allows the PBC (Push Button Configuration)
method, as well as the PIN (Personal Identification Number)
configuration via the web configurator. See your User's Guide for more
information. Other WPS-enabled devices should provide at least one
similar method.
3. The WLAN/WPS LED (
seconds, then shines steadily, indicating your devices are connected.
4. To add another WPS-enabled device to your wireless network, press
the WPS buttons on your P-870HW Series and your next WPS-
enabled device.
Congratulations! You are now ready to connect to the Internet wirelessly
through your P-870HW Series.
10
) on the P-870HW Series blinks for a few
) on the P-870HW Series
Advertisement
