ZyXEL Communications P-794H Quick Start Manual page 5

8 wire g.shdsl cpe with 4 port lan

Hide thumbs Also See for P-794H:

Look at the LEDs (lights) on the top panel of the P-794H.

• The PWR light is on once the P-794H is turned on.

• The LAN light is on if the corresponding LAN port is properly

connected. If you do not connect a computer correctly to this port,

the LAN light will not turn on.

• The CO light is on when the P-794H is operating in CO mode. The

CO light is off when the P-794H is operating in CPE mode.

• The DSL lights blink slowly when there is no DSL connection and

blink rapidly when it is setting up a connnection. Once the DSL

connection is successful, the DSL lights are on.

The LAN lights blink rapidly when the P-794H is sending or receiving

data. If the ALM light is on, there is a connection problem.Try turning the

P-794H off, check the connections, wait a few seconds and then turn it

back on. If the problem persists, you may have a hardware problem and

you need to contact your vendor.

Table of Contents