Adjusting The Shock Absorber Assemblies; Sidestand - Yamaha MAJESTY YP125E Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Adjusting the shock
absorber assemblies
3
1. Spring preload adjusting ring
2. Position indicator
Each shock absorber assembly is
equipped with a spring preload adjus-
ting ring.
CAUTION:
Never attempt to turn an adjusting
mechanism beyond the maximum
or minimum settings.
EAU14880
s WARNING
s
Always adjust both shock absorber
assemblies equally, otherwise poor
handling and loss of stability may
1
result.
Adjust the spring preload as follows.
2
To increase the spring preload and
a
b
thereby harden the suspension, turn
the adjusting ring on each shock
absorber assembly in direction (a). To
decrease the spring preload and the-
reby soften the suspension, turn the
adjusting ring on each shock absor-
ber assembly in direction (b).
NOTE:
Align the appropriate notch in the
ECA10100
adjusting ring with the position indica-
tor on the shock absorber.
Spring preload setting:
Minimum (soft):
1
Standard:
2
Maximum (hard):
4
EWA10210

Sidestand

1
1. Sidestand switch
2. Sidestand
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the motorcycle upright.
NOTE:
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain
situations. (See further down for an
explanation of the ignition circuit cut-
off system.)
3-12
EAU15301
2