Looking After Your Machine - Removing Blockages; Removing Debris From The Brushbar - Vax VUAMM1600T User Manual

Looking After Your Machine -
Removing Blockages
IMPORTANT: If the air inlet, hose or telescopic tube is blocked, switch o the vacuum cleaner and remove the blockage(s) before re-starting
the vacuum cleaner.
Re-setting the brushbar
A RED ashing light will indicate a
jammed brushbar.

Removing debris from the brushbar

NOTE: Brushbar and belt are not removable
If the light continues to ash red after resetting, the brushbar may still be blocked. Using a pair of scissors, cut through any
threads or hairs caught around the brushbar. To access brushbar:
Place the vacuum cleaner on
the oor upside down and
remove the screw on the
back of the brushbar cover.
Removing blockages from the TurboTool
1
7
RED
To reset press the
the middle of the oorhead.
Unclip both clips on the
brushbar cover.
2
GREEN
button in A ashing light indicates
no blockages in the brushbar.
Remove the brushbar cover
and remove and debris, hair
and dirt from the brushbar
and belt.
3
Press the brushbar reset
button again to ensure the
blockage is fully cleared.