Error Codes - Panasonic CF-61 Series Operating Instructions Manual

Error Codes

Startup Error Codes
<For except CF-61KXF4BAM/E model>
<For CF-61KXF4BAM/E model only>
Code
062 Boot failure--default configuration used
101 System Board Failure
102 System Board Failure
106 System Board Failure
114 Adapter ROM Error
151 System Board Failure
161 Bad CMOS Battery
162 Configuration Change Has Occurred
162 Configuration Error
163 Date and Time Incorrect
173 Configuration Change Has Occurred
177 The security passwords have been corrupted
201 Memory Size Error
301 Keyboard Error
303 Keyboard Error
604 Diskette Drive Error
605 Diskette Drive Error
1780 Hard Disk Error
1800 PCI Error
1801 PCI Error
1802 PCI Error
1803 PCI Error
1804 PCI Error
1805 PCI Error
8601 Pointing Device Error
I9990301
I9990305
Battery Error Codes
Code Description
E1 Overcharged
E2 Overdischarged
E3 Cell balance error
E4 Switching error
E5 Temperature is out of range
E6 Exceed maximum charging amount
E7 Exceed maximum charging time
During POST (power on self test) the following error codes may be displayed. They
are also displayed if a hardware failure occurs.
ERROR CODE
XXX
Press F1 key to continue.
Follow the menu displayed.
Setup :
Setup utility (
Next the Setup utility must be run again to input the appropriate operat-
ing environment settings.
Exit :
These messages are ignored, and then the Operating System is started.
Should one of the following error codes appear on the status LCD, reconnect the
battery pack and the AC adaptor.
If the error code continues to be displayed, contact a Panasonic Service Center.
Press and one of these messages follows.
P.27) is started. Run "Load Default Settings (PnP)".
Description
Default configuration in use
Interrupt controller failure
Timer 2 test failure
Diskette controller failure
Adapter ROM checksum error
Real Time Clock failure
Dead battery
Configuration error
CMOS checksum error
Real Time Clock is not updating
ROM configuration changed
Password is corrupted (CMOS RAM is broken)
Memory size/data error
Keyboard failure
Keyboard controller failure
Diskette drive 0 failure
Diskette unlocked problem
Fixed disk 0 failure
No more IRQ available
No more room for option ROM
No more I/O space available
No more memory (above 1 MB) available
No more memory (below 1 MB) available
Checksum error or 0 size Opt. ROM
Pointing device failure
Hard disk failure
An operating system could not be found
Code Description
E8 Serial communication error
E9 Overcharged
EA Temperature is out of range
EB No response from battery
EC Changing current does not decrease
ED Abnormal charging current
37