Replacement Parts - GE Spacemaker WSSH300 Owner's Manual & Installation Instructions

INSTALLING THE WASHER
7. Form a U shape on the end of the drain hose with
the hose pointed toward the drain. Place the hose
in a laundry tub or standpipe and secure it with
the cable tie provided in the enclosure package.
NOTE: If the drain hose is placed in a standpipe
without forming a U shape, a siphoning action could
occur. There must be an air gap around the drain hose.
A snug hose fit can also cause a siphoning action.
Cable Tie
8. Plug the power cord into a grounded outlet.
NOTE: Check to be sure the power is off at a
circuit breaker/fuse box before plugging the power
cord into an outlet.
Installation Instructions
(cont.)
Cable Tie
Cable Tie
16
9. Turn on the power at a circuit breaker/fuse box.
10. Read the rest of this Owner's Manual. It contains
valuable and helpful information that will save you
time and money.
11. Before starting the washer, check to make sure:
❏ Main power is turned on.
❏ The washer is plugged in.
❏ The water faucets are turned on.
❏ The unit is level.
❏ The shipping support hardware is removed
and saved.
❏ The drain hose is properly tied up.
❏ There are no leaks at the faucet, drain line
or washer.
12. Run the washer through a complete cycle. Check
for water leaks and proper operation.
13. If your washer does not operate, please review
the Before You Call For Service section before
calling for service.
14. Place these instructions in a location near the
washer for future reference.

REPLACEMENT PARTS

If replacement parts are needed for your washer, they
can be ordered by visiting our Website at ge.com or by
calling 800.GE.CARES.