Replacement Parts - GE GFWN1000 Owner's Manual & Installation Instructions

Installation Instructions
INSTALLING THE WASHER Icont.}
7. Attach the U-shaped hose guide to the end of the
drain hose. Place the hose in a laundrg tub or
standpipe and secure it with the cable tie provided in
the enclosure package.
NOTE: Placingthe drain hose too far down the drain pipe
can cause a siphoning action. No more than 7 inches of
hose should be in the drain pipe.There must be an air
gap around the drain hose. A snug fit can also cause a
siphoning action.
Cable Tie/
CableTiej_
1
\\
\
\
CableTie
8. Plug the power cord into a grounded outlet.
NOTE:Check to be sure the power is off at the circuit
breaker/fuse box before plugging the power cord into
an outlet.
.
10.
11.
12.
13.
14.
Turn on the power at the circuit breaker/fuse box.
Read the rest of this Owner's Manual. It contains
valuable and helpful information that will save gou
time and moneLI.
Before starting the washer, check to make sure:
[] Main power isturned on.
[] The washer is plugged in.
[] The water faucets are turned on.
[] The unit is level and all four leveling legs are firmlg
on the floor.
[] Theshipping support hardware is removed
and saved.
[] The drain hose is properlg tied up.
[] There are no leaks at the faucet, drain line
or washer.
Run the washer through a complete CLICle.
Check for water leaks and proper operation.
If LlOUrwasher does not operate, please review
the Before You CallFor Servicesection before
calling for service.
Place these instructions in a location near the washer
for future reference.
REPLACEMENT PARTS
If replacement parts are needed for LlOUr w asher,theLI
can be ordered in the United States bLIvisiting our
Website at GEAppliances.com or bg calling
800.GE.CARES.
2O