The Timer; Automatic Time Limitation; Basic Settings - Siemens EH6..TA1.. Instruction Manual

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
Press the symbol several times until the
0
1.
up. appears in the time program function display.
‹‹
Press the + or - symbol on the time program function. The
2.
basic setting will appear.
+ symbol: 10 minutes.
- symbol: 05 minutes.

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
flash alternately.

Basic settings

The device has several basic settings. The settings can be
adapted to the user's own needs.
Indicator Function
Childproof lock
™‚
Off.*
‹
‚ On.
Audible signals
™ƒ
‹ Most signals deactivated.
Some signals deactivated.
‚
ƒ All signals activated.*
Automatic timer
™†
Switched off.*
‹
- Automatic shut-off time
‚ ŠŠ
Duration of the time program function warning signal
™‡
10 seconds*.
‚
30 seconds.
ƒ
1 minute.
„
™ˆ Power-Management function
= Deactivated.*
‹
= 1,000 W. minimum power.
‚
. = 1,500 W.
‚
ƒ = 2,000 W.
etc.
or . = hob maximum power.
Š Š
Return to default settings
™‹
Personal settings.*
‹
‚ Return to factory settings.
* Factory settings
10
Set the time required using the + or - symbols.
3.
After a few seconds, the timer will start to count down.
Once the time has elapsed
A warning beep sounds. In the time program function display
‹‹
the indicators turn off.
indicator lights
W
Pressing the
beep.
Changing or cancelling the time
Press the
up. Change the time with the + or - symbols, or set to
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
" and ‰ selected power level (from 1 to 10 hours).
is shown, and the indicator comes on. After 10 seconds
W
symbol turns off the indicators and stops the
0
symbol several times until the
0
indicator lights
W
.
‹‹