Use Of Dishwasher Salt - Zanussi ZDI121 User Manual

You must set the water softener manually and elec-
tronically.
Manual adjustment
The appliance is set at the factory at position 2.
1
Electronic adjustment
The water softener is set at the factory at level 5.

Use of dishwasher salt

Caution! Only use dishwashers salt. Types of salt
that are not applicable for dishwashers cause
damage to the water softener.
1
3
Fill the salt container with
1 litre of water (only the
first operation).
6
2
Set switch to position 1 or
2.
2
4
1. Press and hold the start/cancel button. Turn the pro-
gramme knob clockwise until the programme marker
agrees with the first washing programme on the con-
trol panel.
2. Release the start/cancel button when the on/off indi-
cator light and the start/cancel indicator light start to
flash.
– At the same time, the end indicator light flashes to
show the level of the water softener.
Example:
5 flashes, pause, 5 flashes, pause, etc... = level 5
3. Press the start/cancel button one time to increase the
water softener level by one step.
The end indicator light shows the new level.
4. Turn the programme knob to the off position to save
the operation.
5
It is normal that water overflows from the salt con-
tainer when you fill it with salt.
Make sure that there is no grain of salt outer of the
salt compartment. Salt which stays on the tank for
a while drills the tank. It is recommended to start a wash-
ing programme immediately after you fill the salt con-
tainer. This prevents of corrosion because of spilled salt.
When you set electronically the water softener to level 1,
the salt indicator light does not stay on.
6