Replacing The Power Supply Assembly - Lenovo ThinkServer TS140 User Manual

Figure 49. Installing the primary hard disk drive
9. Connect one end of the signal cable to the hard disk drive and the other end to an available SATA
connector on the system board. See "Locating parts on the system board" on page 15. Then, locate an
available five-wire power connector and connect it to the hard disk drive.
Figure 50. Connecting a SATA hard disk drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 79.

Replacing the power supply assembly

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 35.
This section provides instructions on how to replace the power supply assembly.
Although there are no moving parts in your server after the power cord has been disconnected, the following
warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
66
ThinkServer TS140 User Guide