Advertisement
You can also set the following settings that apply
to both outputs:
Option
Description
DEFAULT FRAME
Set to 50p (PAL) or 60p
RATE
(NTSC) to specify the native
system of your display.
TESTPATTERN
Displays one of a set of
alternative test patterns for
aligning projection displays.
s P e A k e r s e t t i n g
The SPEAKER SETTING menu allows you to
set up the speakers:
Option
Description
MODE
See below.
FRONT L+R
Select SMALL or LARGE
to specify whether the front
speakers can handle bass.
CENTER
Select NONE, SMALL, or
LARGE to specify whether
there is a center speaker in the
system, and whether it is small
or large.
Select NONE, SMALL, or
SURROUND
LARGE to specify information
about the surround speakers.
SURR BACK
Select NONE, 1/SMALL,
1/LARGE, 2/SMALL, or 2/
LARGE to specify the number
and size of the surround back
speakers.
SUBWOOFER
Select OFF or ON to specify
whether the layout should
include a subwoofer.
LR+LFE XOVER
Allows you to define the
CENTER XOVER
crossover frequency (40Hz
SURR XOVER
to 200Hz) used for the LFE,
CENTER, and SURR speakers.
•
Set MODE to GENERAL, and then set
the other parameters as appropriate for the
speakers in your system.
You can then define DOLBY D, DTS, and
OTHER modes, which can be used to add an
offset to the GENERAL settings for Dolby
Digital, DTS, and 2-channel sources respectively.
s P A 2 3 u s e r g u i d e
l e V e l A d J u s t
The LEVEL ADJUST menu allows you to adjust
the levels so that the sound from each speaker is
equally loud at the listening position.
•
Highlight each of the speakers in turn; a white
noise signal will be played through the speaker.
•
Use the < and > buttons on the remote
control to adjust the level.
For best results measure the level at the listening
position using a Sound Pressure Level meter.
1 0
Advertisement
