Procedure; Installing/Removing Processor - Fujitsu D3171 Information

6 - English

Procedure

The processor socket is covered with a protective cap to protect the spring
contacts. In the event of a warranty case, the mainboard can only be taken back
by Fujitsu Technology Solutions with the protective cap secured!
b
Please note that, depending on the heat sink used, different heat sink
mounts are required on the mainboard.
► Depending on the configuration variant, you must pull a protective foil off the heat sink
or coat the heat sink with heat conducting paste before fitting it.
► Secure the heat sink - depending on the model - with four screws or push it into the mounts.
18
► Remove the heat sink.
► Press down the lever and unhook it.
► Fold up the frame.
► Hold the processor between your thumb
► Press the lever downward until it is
a
► Remove the protective cap and keep it.
b
Installing/removing the processor
and index finger and insert it into the socket
(b) so that the marking of the processor is
aligned with the marking on the socket (a).
hooked in again.
Fujitsu Technology Solutions