Advertisement
1 Be sure the bobbin winder is on the
right-hand side[]and is steady.
______________
_______
2, Put the thread spool in the spool holder. Pull
the thread through the thread guide 1 & 2, and
wind it around the bottom of the adjusting screw from
the right to the left and ensure the thread is wound
between the two metal clamps of the adjusting screw.
3, Continue to put the thread through the hole of thread take up lever to thread guide 3.
4, Pull the thread through the needle eye, you may need to turn the hand wheel to raise the
needle.
5, Lift the presser foot, by using the presser foot lever and then slide the thread under the
presser foot toward the back of the machine. Lower the presser foot.
1,
Open the bottom thread bobbin case cover.
2, Take out the bottom thread bobbin from bottom bobbin holder.
3. Insert the bottom thread fetcher into the bobbin as pictured.
4, Keep bottom thread tail 5 cm long and counter-clockwise forward when bottom bobbin is
placed into bobbin holder.
5, For smooth threading on bottom bobbin case, hold fetcher together with
bobbin by
your
left hand and 5cm long thread tail by
your right hand. Place thread tail against
the right notch(inside) on bobbin case,
let the right notch hook the thread tail
when put down bobbin. Turn thread tail
clockwise to the left notch(outside) after
the right notch hook the thread, and then
pull thread tail 3 cm long from the left
notch.
6, Take away the fetcher and keep
bottom bobbin in bobbin case, and then place the bobbin cover in its position
7. Hold the top thread with your left hand and at the same time turn the hand wheel in a
counter-clockwise direction with your right hand one complete revolution. This will bring the
L
_____
Advertisement
