Care And Cleaning; Before You Call For Service - GE Monogram ZVB30 Owner's Manual

Grease filters
Painted or
stainless steel
surfaces
Save time
and money!
Review the
troubleshooting
tips on this
page first and
you may not
need to call
for service.
The efficiency of your downdraft depends on a
clean filter. Frequency of cleaning depends on the
type of cooking you do. Grease filters should be
cleaned at least once a month. Never operate the
downdraft without the filters in place.
To remove: Pull the filters out by grasping them
and pulling straight up.
To clean: Soak and then agitate in a hot detergent
solution. Light brushing may be used to remove
embedded soil. Rinse, shake and remove moisture
before replacing.
With careful handling, the filter will last for years.
If replacement becomes necessary, order the part
from your dealer.
Do not use a steel-wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm
sudsy water, a stainless steel cleaner such as
Kleen King ® , or an all-purpose liquid or spray
cleaner. Always scrub in the direction of the
grain. Rinse thoroughly with a sponge or cloth
and clean water. Dry with a soft, clean cloth.
After cleaning, use a stainless steel polish, such
®
as Stainless Steel Magic , Revere Copper and
Stainless Steel Cleaner ® , or Wenol All Purpose
Metal Polish ® . Follow the product instructions
for cleaning the stainless steel surface.
PROBLEM
FAN DOES
NOT WORK
VENT DOES
NOT WORK

Care and Cleaning

Before You Call For Service...

POSSIBLE CAUSE
• The vent is not fully extended. Press the raise/lower pad.
• The blower control switch may be in the OFF position.
Slide it to the right.
• The vent is not plugged into an outlet. Plug the vent into a 120V
power outlet.
• The raise/lower pad did not engage the lift motor. Hold down the
pad for a couple of seconds to activate the motor.
• The circuit breaker may have tripped. Check the circuit breaker—
reset if necessary.
Downdraft Vent System
Downdraft Vent System
9