Ignition System Faults
The SmartSwitch Ignition is programmed to warn
when any part of the safety system is not being
followed and will not allow the unit to be started until
all system faults are resolved.
The park brake fault light will blink if the park brake
has not been engaged.
The blade switch fault light will blink if the blade
control switch has not been disengaged (down
position) or is disconnected.
The motion control fault light will blink if the motion
control levers are not in the neutral (outer) position.
OPERATION
Park brake fault light
Blade switch fault light
Motion control lever fault light
8058-237
8058-238
8058-239
31