6. Print a menu settings page. Compare these settings to those on the page
7. Place the Option Added label on the printer next to the printer model and
Crypto Officer Guidance
The Crypto Officer is responsible for activating, deactivating and monitoring the
module. The DLE card comes in a static sensitive package. Upon receiving the
PrintCryption DLE card, the Crypto Officer should check for any signs of
tampering to the package, including a damaged seal or package.
The Crypto Officer may follow the installation sheet found in the option kit to
install the PrintCryption DLE card. After the installation is complete, the Crypto
Officer must print a Menu page and verify that Lexmark PrintCryption Card is
displayed under the Installed Features section of the Menu Page.
The Crypto Officer must configure the printer onto the TCP/IP network per
installation requirements. While installing the PrintCryption host software
application on a PC, Crypto Officer must choose port 9150 to communicate with
the printer. It is recommended that Crypto Officer name the port "FIPS" to clearly
distinguish the port that provides secured printing service.
User Guidance
The user software is a separate module which is not covered by this validation.
This section is provided for the convenience of the user.
The User accesses the module printing functionality as a user over network.
Although outside the boundary of the module, the User should be careful to use
secured printing services as needed.
© Copyright 2009 Lexmark International Inc.
This document may be freely reproduced and distributed whole and intact including this Copyright Notice.
instructions on installing the software. The setup executable, once
launched, will:
a. Ask for confirmation of the End-User License Agreement.
b. Present a small README, which explains that after installation,
the Crypto Officer can add a new port to their printer driver that
will support Lexmark PrintCryption
Note: Please refer to Crypto Officer Guidance section for more
information.
c. Perform the installation, and stop and restart the print spooler.
printed in step 1.
serial number label. Lexmark provides the Option Added label with the
Installation guide.
Page 16 of 20
TM
.
Need help?
Do you have a question about the 10G0149 - PrintCryption Card Encryption Module and is the answer not in the manual?